Thinkware H100 User Manual download pdf (Page 10)

1-5-3. Connecting to power

①

Connect the power cable to DC-IN socket of the

device.

②

Plug the charger adapter end of the power cable

into a 12V DC vehicle power socket.

③

Arrange the wire by using the adhesive cable holder

as shown below.

④

The dash cam should be facing forwarding and

level with the vehicle and the road. Adjust the

camera using the level guiding line marked on the

side of the device.

After installation, run the dash cam to record videos and

check the videos using Thinkware Dash Cam Viewer to verify

camera position. Adjust the camera angle if necessary.

TIP

Adjust the camera to have the horizontal indica tor on the

dash cam to be level with the vehicle and the road.

TIP

RESET

ESET

RES

RESE

Guiding Line

Preventing Vehicle Battery Discharge

■ Depending on the car make and model, the power from the vehicle can be supplied even with

the ignition turned off. In this case, the dash cam stays on as continuous mode and does not

enter parking surveillance mode which will result in vehicle battery discharge.

■ Some vehicles with multiple power sockets might be equipped with at least 1 outlet that does

not shut off the power with the ignition. So, test each power outlet to ensure you connect to an

outlet that shut off with vehicle engine.

For more information on the power cable routing instruction, please visit Thinkware homepage

(http://thinkwaredashcam.com)

Recommended location for ad-

hesive wires clips are illustrated

in the diagram

Hide the extra wires by placing the wires

in the space between the ceiling of vehicle

and the top of the windshield.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

No comments

Thinkware H100 User Manual Page 10